| About this product | |
|---|---|
| Product | D-Link DWL-520 Wireless 802.11b PCI Adapter |
| Vendor | D-Link |
| Tested operating systems | Ark Linux Linux other Slackware Linux |
| Average rating | |
| CompatDB XML | dlink-dwl520-wireless-80211b-pci-adapter.xml |
Compatibility Reports for D-Link DWL-520 Wireless 802.11b PCI Adapter
Reported by Anonymous
Rating
Operating system
Ark Linux
Date
-
Reported by Anonymous
Rating
Operating system
Slackware Linux
Date
I hope the peeps that have had trouble in the past have since found out about madwifi drivers because I've used this card with Slackware, Slax, Phlak, Xandros, Kubuntu, and even Knoppix and it works just super. It's very fast and has a solid, stable connection even under adverse conditions ie: many walls in between it and router. Many distros autodetect and setup right from boot 1. There is no need for ndiswrapper or any other jumping thru hoops. Just get madwifi drivers, from subversion (formerly CVS) if you want cutting edge support or simply what is generally available for your kernel or build easily from source. It's a no-brainer even from source and works really well. Highly recommended.
Jimmy
Reported by Anonymous
Rating
Operating system
Linux other
Date
I am also running rev D of this card. I have only found it runs on hardly any distos. list goes as follows.
sabayonlinux - would not load device gets picked up incorrectly wont load in ndiswrapper
dreamlinux - as above will not work at all
samlinux(pclinOS) - works ok with inbuilt software
mepis 6.5 - works great
Reported by Anonymous
Rating
Operating system
Linux other
Date
My DWL-520 is revision D, using the Realtek RTL8180 chip. Revisions A,B, and E use another chip, and Revision C uses yet another.
The D-Link driver must be force-loaded and only support a few configuration functions in Debian with kernel 2.4.22. The compiled driver refuses to load at all!
Reported by Anonymous
Rating
Operating system
Linux other
Date
Works fine with the Prism2 driver. Seen by linux networking as wlan0.
