Reported by Anonymous

---

detected and set OK right away after plugin
then ifup got it an IP@ using DHCP
debian sarge 2.4.27 updated to etch and still running

Reported by Anonymous

---

I'm using Ubuntu 8.04 kernel 2.6.24-18-generic.

Everything works by just pluging it in:

4151.076069 eth1: register 'asix' at usb-0000:00:1d.7-5, ASIX AX88772 USB 2.0 Ethernet, 00:1d:7e:01:37:44
4151.076112 usbcore: registered new interface driver asix
4151.283277 eth1: link down
4151.289148 ADDRCONF(NETDEV_UP): eth1: link is not ready
4156.540327 tg3: eth0: Link is down.
4160.739038 ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
4160.742292 eth1: link up, 100Mbps, full-duplex, lpa 0xC5E1
4168.385975 usb 4-5: USB disconnect, address 5
4168.386591 eth1: unregister 'asix' usb-0000:00:1d.7-5, ASIX AX88772 USB 2.0 Ethernet

Reported by Anonymous

---

Works fully under Slax 5, not at all under Puppy 2, as they are both outdated comments on Puppy might not be true anymore. USB200M VER2

Reported by Anonymous

---

works out of the box with 2.6.22, ethernet interface created immediately, no problem

Reported by Anonymous

---

This product is not properly working on my machine. I can see messages when it is plugged in. Device (eth) is created and the device can be pinged.

I cannot make it work to send data or ping outside of the box.

Reported by Anonymous

---

I have a Linksys USB200M ver 2.1 and it will not work on Ubuntu. The device is recognized and handled by usbnet. A network interface is created, but no traffic is successfully transmitted. Previous versions of this device worked well with usbnet.

Reported by Anonymous

---

usbnet