Interactive Startup

This is a discussion about Interactive Startup in the Everything Linux category; ok, whenever im not connected to the internet on my linux box (mandrake 9. 2) it always wont start unless if i do it interactivly and dont allow the eht0 to load. . i know what to do. . its just its a pain.

Everything Linux 1798 This topic was started by , . Last reply by ,


data/avatar/default/avatar30.webp

84 Posts
Location -
Joined 2003-12-27
ok, whenever im not connected to the internet on my linux box (mandrake 9.2) it always wont start unless if i do it interactivly and dont allow the eht0 to load.. i know what to do.. its just its a pain... is there any other way?

Participate in our website and join the conversation

You already have an account on our website? To log in, use the link provided below.
Login
Create a new user account. Registration is free and takes only a few seconds.
Register
This subject has been archived. New comments and votes cannot be submitted.
Dec 31
Created
Jan 3
Last Response
0
Likes
1 minute
Read Time
User User User
Users

Responses to this topic


data/avatar/default/avatar12.webp

30 Posts
Location -
Joined 2003-12-30
You can turn network services off by default.
 
However, even with networking enabled, it should eventually load anyway, though it may take a while to do so if there is no ethernet connection available.

data/avatar/default/avatar37.webp

213 Posts
Location -
Joined 2004-01-02
It takes a long time compared to the other things that are going on. Have you ever waited a couple of minutes to see if it continues? ;(

data/avatar/default/avatar30.webp

84 Posts
Location -
Joined 2003-12-27
OP
bah im too lazy to wait.. i just do interactive setup