Suse 9.2 ATI vid card and S-Video
This is a discussion about Suse 9.2 ATI vid card and S-Video in the Everything Linux category; I have my box connected to my TV using a S-Vid Cable. Everything works good until the X desktop comes up and then the card always goes to something other then 640x480@60Hz. I have tried many times to change the settings in yast, and it does seem to do the resolution correctly, but I just can't make it do the refres ...
I have my box connected to my TV using a S-Vid Cable.
Everything works good until the X desktop comes up and then the card always goes to something other then 640x480@60Hz.
I have tried many times to change the settings in yast, and it does seem to do the resolution correctly, but I just can't make it do the refresh rate that I want, at one point I found a set of choices for refresh rate, but they were 58Hz and 65Hz, not the the 60Hz. BTW I am also shooting for NTSC-N (Canada) I think what those where was PAL.
What am I missing?
Everything works good until the X desktop comes up and then the card always goes to something other then 640x480@60Hz.
I have tried many times to change the settings in yast, and it does seem to do the resolution correctly, but I just can't make it do the refresh rate that I want, at one point I found a set of choices for refresh rate, but they were 58Hz and 65Hz, not the the 60Hz. BTW I am also shooting for NTSC-N (Canada) I think what those where was PAL.
What am I missing?
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
